Lenze 8600 series - Reset of the Diameter Compensator

To activate the diameter compensator the threshold which is to be
set under C94 must be decreased so that the dancer-Position
controller tan be activated. With the setting of Cl 94 = 100 %
(factory setting) the diameter compensator is disconnected from
the dancer-Position controller.
-
9.10.1 Reset of the diameter compensator
The diameter compensator tan be reset (e.g. after finishing the
winding process) via a freely assignable digital input, the operating
unit, or the LECOM interfaces.
Select the freely assignable terminal which is to be assigned to the
function “diameter compensator reset” via code Cl 12. This function
is assigned to the freely assignable terminal under code Cl 13. If
the diameter compensator is enabled via the freely assignable
terminal, the thresholds will be compared first. When activating the
“diameter compensator reset”, the counter value is set to Zero.
After each mains connection, the diameter compensator is set to
Zero.
-
Caution!
If the controller is enabled when the diameter compensator is reset,
then the counter value is set to zero immediately. Thus, with a high
diameter compensator percentage - when activating the “diameter
compensator reset” - the diameter value which is part of the
division changes abruptly and as a result the field frequency is also
changed. This may lead to high accelerations and the current
limiting function Imax may be activated.
The integration time tan be set under code Cl 95 (unit [s]), and the
decrement time tan be determined under Cl96 (unit [s]).
If the output of the dancer-Position controller falls below the
threshold set under Cl 94 after the diameter compensator has
already been activated, the correction value of the diameter
compensator will not be changed as long as
l the diameter compensator is reset via a freely assignable
terminal or
l the supply voltage of the frequency controller is switched off
(e.g. the controller is not connected to the mains) or
l the diameter compensator has to be activated again because
the output of the dancer-Position controller exceeds the
threshold set under Cl 94.
The function Cl 94 is not reset by controller inhibit.
The threshold set under Cl 94 refers to 100% of the modulation of
the dancer-Position controller.
INFO: 100 % = Diameter compensator swtiched off.
The thresholds for positive and negative
-
116