Lenze 8600 series - Programming of the Freely Assignable Inputs and Outputs; Freely Assignable Digital Inputs

5 Programming of the freely assignable inputs and
Outputs
Most of the inputs and outputs of the frequency controller are
freely assignable via their own Codes, i.e. they tan be especially
assigned to the required Signals. Furthermore, these Signals tan
be adjusted in the best possible way by setting facilities.
In factory setting, these inputs are already assigned to certain
functions.
5.1
Freely assignable digital inputs
Factory setting:
Input
El
r
Function Activation
Set TRIP HIGH
E2 Reset TRIP HIGH
E3
Activate DC-injection brake HIGH
E4, E5, E6
Enable JOG frequencies
HIGH
E7, E8 Enable additional acceleration and deceleration times HIGH
-
Changing the functions
If you want to assign an input with a function, which has not been
assigned yet, proceed as follows:
l Select the input which you want to assign under code Cl 12.
l !S.elect the required function under code Cl 13.
l Determine under code Cl 14 whether the function is to be
activated with a HIGH or with a LOW Signal.
l Determine under code Cl 15 whether the function is to be
(activated always via terminal or, depending on the operating
mode, via the interface which has been selected for control
Enable additional acceleration and
deceleration times
Enable JOG frequencies
Activate DC-injection brake
Integral action component = 0
Ramp generator stop
-10- Ramp-generator input = 0
-2O- Select Parameter set
-21- Load Parameter set
-ZOO- Reset I-component dancer-Position controller
-201- Reset D-component dancer-position controller
-202- Suppression dancer-Position controller
lenze
81