Lenze 8600 series - Ramp Generator Stop; Ramp Generator Input; Integral Action Component

5.2.6 Ramp generator stop
While the drive is accelerated via the ramp generator of the main
setpoint, you tan hold the ramp generator using the assigned
digital input, e.g. to wait for cet-tain actions before accelerating.
With terminal control you tan read under Cl31 whether the
ramp generator is stopped or not.
With control via the keypad or the LECOM interfaces the ramp
generator (main setpoint) is stopped and enabled again under
C131.
Code Name Parameter (Factory setting is printed in bold) Acceptance
Cl31 Ramp gener. -O- Enable ramp generator SH + PRG
stop
-l-
Stop ramp generator
5.2.7 Ramp generator input = 0
If you want to stop the drive independently of the main setpoint
(setpoint i/JOG frequency) you tan switch the ramp generator
input input to zero using the assigned input. This Causes the drive
to brake with the set deceleration time. When the function is
deactivated, the main setpoint is enabled again and the drive
accelerates normally.
With terminal control Cl32 serves as display whether the ramp
generator input is set to zero or not.
With control via keypad or LECOM interfaces you tan set the ramp
generator to zero and enable it again under Cl 32.
Code Name
Parameter (Factory setting is printed in bold) Acceptance
Cl32 Ramp-
-o- Ramp generator input enabled SH + PRG
generator input -l- Ramp generator input = O/
=
0 set to zero
5.2.8 Integral action component = 0
In configurations with Pl controller you tan set the integral action
component of the controller to zero using the assigned input. See
page 80.
-
88
lenze