2.5.2 EC
Declaration
of Conformity ‘95
for the purpose of the EC
Directive
relating to
Electromagnetit
Compatibility
(89/336/EEC)
amended by: First amended directive
(92/31/EEC)
CE mark directive
(93/68/EEC)
The controllers of the 8600 series
cannot
be driven in stand-alone
Operation for the purpose of the regulation
about
electromagnetic
compatibility (EMVG of
09/11/92
and 1st
EMVGÄndG
-
amended
directive
-
of
30/08/95).
The EMC
tan
only be
checked
when
integrating the
controller
into a drive System.
Lenze GmbH
&
Co KG, Postfach 10 13 52, D-31763 Hameln
declares that the described “CE-typical drive
Systems”
with the
controllers of the type
820~
und
821~
comply with the above
mentioned EC directive.
The compliance with the protective requirements of the above
mentioned EC directive was confirmed by the award of the
VDE-
EMC
label
of the accredited test laboratory: VDE Prüf- und
Zet-tifizierungsinstitut, Offenbach
The conformity evaluation is based on the working
Paper
of the
product Standard for drive Systems:
IIEC
22G-WG4
5/94
1
EMC product
standard
including specific
test
methods for power drive Systems
I
Considered generic Standards:
Generic
Standard
EN
50081-1
Generic Standard for the emission of noise
192
Part 1: Residential areas, commercial premises, and
small
businesses
EN
50081-2
193
Generic Standard for the emission of noise
(used in addition to
the
Part
2: Industrial premises
requirements of IEC The emission of noise in
industrial
premises is
not
limited in
22G) IEC 22G.
prEN
50082-2
3194 Generic Standard for noise immunity
Part 2: Industrial premises
The requirements of noise immunity for residential areas were
not
considered
since
these are less
stritt.
Considered
basic
Standards for the test of noise emission:
Housing and mains
15
-
1000 MHz
Ise
in industrial
Standard is used in addition to the
for use in residential and commercial
n
industrial premises
16
bue
To Next Page
Loading...
