Lenze 8600 series - JOG Frequencies

5.2.4 JOG frequencies
If you need cer-tain fixed settings as main setpoint, you tan cal1
programmed setpoints via the JOG frequencies. These JOG
frequencies replace setpoint 1. Please note that in configurations
with additional setpoints, the setpoint 2 is set to zero, as long as a
JOG frequency is active.
Programming of JOG frequencies
The JOG frequencies are set in two Steps:
l Select a JOG frequency under CO38
l Under CO39, enter a value which you want to assign to the
selected JOG frequency
If you require several JOG frequencies, repeat the first two Steps
correspondingly. The JOG frequencies must be entered as
absolute values. A maximum of 15 JOG frequencies tan be
programmed.
Code Name Parameter (Factory setting is printed in bold)
Acceptance
CO38 Preselection: -l- JOG 1
SH + PRG
JOG
-27 JOG 2
frequency . . . .
-15 JOG 15
CO39 Setpoint for 50.OHz
-480 Hz
(1 Hz1
-100 Hz ON-LINE
CO38
-100 Hz (0.1 Hz} +lOO Hz
+lOO Hz
(1 Hz1
480 Hz)
Assignment of the digital inputs
The number of required inputs for the function “Enable JOG
frequency” depends on the amount of the required JOG
frequencies.
Number of required JOG
frequencies
1
Number of requlred inputs
at least 1
2...3
4...7
8...15
at least 2
at least 3
4
A maximum of four inputs tan be assigned to this function. For the
assignment of the inputs see the notes on page 81.
84
lmze