Enabling JOG frequencies
With terminal control activate the assigned digital inputs
according to the table below.
The input with the smallest number is the first input, the input with
the next highest number is the second input, etc.
(e.g.
E4 = first input, E5 = second input).
With terminal control, the
active
JOG frequency is displayed
under
co4.5.
With control via keypad or LECOM
interfaces
CO45 is used to
activate the JOG frequencies.
Code Name
I-
Parameter (Factory setting is printed in bold)
CO45 Enable
-O-
Setpoint
1
acivelactivate
JOG
setpoint
-1-
Setpoint
JOG 1
activelactivate
. .
-15- Setpoint
JOG 15
active/activate
Acceptance
SH
+
PRG
85
To Next Page
Loading...
