Lenze 8600 series - Functions of the Freely Assignable Digital Inputs; Set TRIP; Reset TRIP

[Code IName
1 Parameter (Factoty setting is printed in bold)
Function tan be changed via CO01
Function tan be activated via terminals
indeoendentlv at CO01
Acceptance
[SH + PRG]
Except for the functions “Enable JOG frequencies”, “Enable additional
acceleration and decleration times” and “Select Parameter Set”, every
function tan only be assigned to one terminal. If you want to re-assign
an input, the previous programming is lost.
A function tan only be assigned to one input. A double assignment is
not possible.
5.2
Functions of the freely assignable digital inputs
5.2.1 Set TRIP
The controller receives a TRIP message via the assigned input.
Using the code Cl 19 and Cl 20, you tan program the monitoring
of the input such that in case of fault indications
l these indications are ignored,
l TRIP is activated or
l a warning is activated.
Select the TRIP set input by entering Cl 19 = -0- and program the
function via Cl 20 (see page 99).
L
:ode
IName IParameter (Factory setting is printed in bold)
719 1 Preselection: I-O- Dlgltai Input TRIP-Set
Monitoring -l- PTC input
-15 Output power (1 t monitoring)
320
Function for For Cl19 = -O-. -l-
Cl19 -Ck
Monitoring not active
-l- Monltoring active, sets trip
-2- Monitoring active, sets waming
For Cl19= -15
Q Rated power for temperature range up
to 50°C
-1- Increased power for temperature
range up to 45°C
-2- Maximum power for temperature
range up to 40°C
Acceptance
SH + PRG
t-
SH + PRG
L
5.2.2 Reset TRIP
A fault which Causes a TRIP is automatically displayed under CO67
and is indicated e.g. via the relay output. To reset the TRIP
memory, you tan use the input which is assigned to the TRIP reset
function or press the keys SH + PRG.
J
82
hze