Lenze 8600 series - Digital Frequency Input; Control Mode

Gain
Set the Signal gain after the offset adjustment.
First apply that Signal to which you want to adjust the internal display
(see offset). Then select under CO25 the corresponding analog
input. Adjust the Signal gain such that the desired setpoint is
obtained. For the adjustment of the act. value see pages 75 and 77.
:ode Name
=025
Parameter Acceptancc
Preselection: -l- Analog input Xl/terminals 1/2
SH + PRG
Encoder -2-
Analog input Xl/terminals 3/4
-4 Analog input Xl/terminal 8
-lO- Digital frequencyfincremental encoder
input X5
-11- Digital frequency/incremental encoder
input X8
:026 Constant for
CO25 = -l-, -2-, -4-
ON-LINE
CO25
(preselection of the analog inputs):
xxxx mV factory setting
-1000 mV
(1 mvl
+iOOO mV
CO25 = -1 o-, -ll-
ON-LINE
(preselection of the digital-frequency
inputsfincremental encoder inputs):
-l- 512 pulsc/Hz or incrementslrevolution
-2- 1024 pulseklz or incrementslrevolution
-3- 2048 pulse/Hz or incrementslrevolution
-4- 4096 pulse/Hz or increments/revolution
5% Adjustment for CO25 = -l-, -2-, -4- ON-LINE
CO25 (preselection of the analog inputs):
1 .ooo -2.500 (0.001) +2
-
CO25 = -lO-, -1 l-
(preselection of the digital-frequency
inputs/incremental encoder inputs):
1 .ooo -5.000 (0.001) +5.000
3.7
Control mode
Under Code CO06 you tan select V/f-characteristic control or Io
control.
-
Code
E
Name Parameter (Factory setting is printed in bold) Acceptance
CO06 Control mode -O-
V/f-characteristic control [SH + PRG]
-l- IO -control (only for Single drives)
-
lmue
69