Lenze 8600 series - Code Table

11 Code table
The following table Shows which settings you tan enter under
which Codes. For detailed explanations of the Codes and their
possible functions refer to the corresponding chapters.
How to read the code table:
Column Abbreviation Meanlng
Code
CO00 Code of the Standard code set
coo5*
Code of the extended code set
Parameter Q
Factory setting is printed in hold.
1 (l} 99 minimumvalue
(increment}
INFO:
Important brief information about the code
Acceatance ON-LINE
Controller immediately accepts the new Parameter
maximum value
SH + PRG
[SH + PRG]
Controller accepts the new Parameters after pressing SH + PRG
Controller accepts the new Parameters only if the controller is inhibited when
pressing SH + PRG.
c
Zode
Name Parameter
Acceptance see Your
(Factory setting is printed in bold)
page settings
2000 Code set
-o- Standard code set read only
SH + PRG 100
-l- Standard code set
-2- Extended code set
-9- Service code set
2001 Operating
Control Programming
[SH + PRG] 59
mode
-Cl-
Terminals Keypad
-l- Keypad
Keypad
-2- Terminals LECOM 1 (X6)
-3- LECOM 1 (X6) LECOM 1 (X6)
-4- Terminals LECOM 2
-5
LECOM 2 LECOM 2
-6-
LECOM 2 Keypad
-7- LECOM 2
LECOM 1
CO02
Load -o-
Factory setting
[SH + PRG] 58,
Parameter set -l-
Parameter set 1
89
-2- Parameter set 2
-3- Parameter set 3
-4- Parameter set 4
CO03 Store
Parameter set
::- Parameter set 1
SH+PRG 58,
Parameter set 2 89
-3- Parameter set 3
-4- Parameter set 4
CO04
Switch-on xxx Code number for display after mains
SH+PRG 101
display
connection
130
lenze