Lenze 8600 series - Mains Chokes

Moulded module resistors on heatsink
I ,
,k-i
I
d
b
Brake resistor
Dimensions
Resistance Order number
a
b
C d e
Cl
k
a mm mm mm mm mm mm
mm
370 ERBM370R15OW 80 240 70 225 95 5 7.5
240 ERBM240R200W 80 340 70 325 70 5 7.5
Brake resistor
Resistance Order number
n
370 ERBM370R15OW
240 ERBM240R200W
Power
kW
0.15
0.2
Resistor values
Peak brake power
kW
1.4
2.2
Heat capacitance
kWs
30
30
6.2
Mains Chokes
Advantages of using a mains Choke:
l Less mains disturbance
The wave shape of the mains current approaches sinusoidal; at
the same time the r.m.s. current is reduced by up to 40%
(reduction of the mains load, the cable load and the fuse load).
l Increased life of the Controller
A mains Choke reduces the AC load of the DC bus capacitors
and thus doubles its Service life.
l The transient high-energy overvoltages which are sometimes
generated at the mains side by circuit breakers or fuses are
stopped by the mains Choke and thus the units are usually not
damaged.
l Low-frequent radio interference tan be reduced.
Please note:
l When a mains Choke is used, the maximum possible output
voltage does not resch the value of the mains voltage.
- typicat voltage drop at the rated Point: 4 to 5%.
l Mains Chokes are always required when the Controller is
operated with increased or maximum power.
-
42 lmze