Lenze 8600 series - Basic Settings; Operating Mode

-
3
Basic settings
3.1
Operating mode
The controllers of the 8600 series offer different interfaces. From
these you tan select each one for control and programming.
Controller interfaces for control and programming:
Terminals The terminals are exclusively used to control the
controller.
Keyp’ad
The five keys and the plain text display tan be
used mainly for programming. A control via the
keypad is also possible.
LECOM 1 LECOMl means the connection for LECOMNB
(connector X6) which tan be used for programming
via a PC or other master Systems. The Signals are
processed according to the FIS232 and FIS.485
Standards. You tan connect the controller to a
host using the X6 connector.
For further information about LECOMI
see page 140.
LECOM2 For more sophisticated applications, you tan
control and program the controller via a field bus
connecting module using LECOM2. Here, the field
bus Systems InterBus-S or PROFIBUS with the
DRIVECOM Profile are used. For further
information about LECOM2 see page 141.
You tan set the desired combination using code CO01 “operating
mode”:
--
:0Ck!
--
:001
--
Name
3perating
mode
IParameter (Factory setting is printed in bold) kceptancr
Control Parameter setting - SH + PRG]
-o- Klemmen Keypad
-l- Keypad Keypad
.2- Terminals LECOM 1 (X6)
.3- LECOM 1 (X6) LECOM 1 (X6)
-4- Terminals LECOM 2
-5-
LECOM 2 LECOM 2
-6- LECOM 2 Keypad
-7- LECOM 2 LECOM 1
Please note that the functions “controller enable” and “quick stop”
always remain active via the assigned terminals, independently of
the selected operating mode.