Lenze 8600 series - Line Drives; Grinding and Cutting-Off Wheel Drives

-
9.1.2 Line drives
l Dancer-Position control with and without Pilot control of the line
Speed
l Dancer-Position control with Speed adaptation and Pilot control
of the line Speed
86xx 1 -166~~ VOOSl
L
VSdl -v
T
T
Damm-controlled line drive
9.1.3 Grinding and cutting-off wheel drives
l Control of contstant surface Speed via non-contact diameter
detection.
-
d
1
d
Grinding or cutting-oft wheel drives
Important information about the dancer-Position control:
l The analog inputs Xl /terminals. 1, 2 and Xl/terminals. 3, 4 are
always active, independently of the operating mode.
l ‘When reading the following setting instructions, please note that
,the minimum diameter requires the maximum frequency of the
drive.
lmze
103