Lenze 8600 series - Functions of the Freely Assignable Digital Outputs; Frequency below a Certain Threshold, Qmin

1
:ode Name
Parameter (Facto- setting is printed in bold)
Acceptancf
;116 Preselection: -l-
Digital output Al
SH + PRG
freely -2-
Digital output A2
assignable -3-
Digital output A3
digital output -4- Digital output A4
-5 Relay output Kl l/K14
;117
Function for -o- No function
SH + PRG
Cl16 -l-
Output frequency smaller than
Qmln -threshold
-3- Maximum current reached
-4- Ready
-5 Pulse inhibit
-6- Fault indication
-9-
Setpoint reached
-lO- Act. value = setpoint
-1 l- Act. value = 0
;118 Polarity for -o- Output HIGH active
SH + PRG
Cl17 -l- Output LOW active
Every function tan only be assigned to one output, including the
relay output. If you want to re-assign an output, the previous
progr,amming is lost.
A funlction which is already assigned to an output, tan only be
assigned to another terminal or the relay output, if the previously
used output has been assigned to another function.
5.4
Functions of the freely assignable digital Outputs
5.4.1 Frequency below a certain threshold, Qmin
The controller indicates via the assigned output that the output
frequency is smaller than the threshold set under C017. For example,
you c:an use the output for a holding brake and program under CO17
at which output frequency the brake is to be released or engaged.
Code
t
Name
Parameter (Factory setting is printed in bold) Acceptance
CO17 Threshold for 2 Hz 7.5 Hz (0.1 Hz} 100 Hz ON-LINE
Qm,, function 100Hz
11 Hz1
480 Hz)
-
-
91