Lenze 9300 Servo PLC - Page 141

9300 Servo PLC
Appendix
4-6

9300ServoPLC EN 1.4
Fault message Possible settings / Reaction
Display CodeOffFault/
QSP
Warn in gMessageTRIPMeaningError
no.
float T Id2 211 Floating point error (REAL) in the task with Id2 w - á á - 1)
float T Id3 212 Floating point error (REAL) in task with Id.3 w - á á - 1)
float T Id4 213 Floating point error (REAL) in task with Id.4 w - á á - 1)
float T Id5 214 Floating point error (REAL) in task with Id.5 w - á á - 1)
float T Id6 215 Floating point error (REAL) in task with Id.6 w - á á - 1)
float T Id7 216 Floating point error (REAL) in task with Id.7 w - á á - 1)
float T Id8 217 Floating point error (REAL) in task with Id.8 w - á á - 1)
float T Id9 218 Floating point error (REAL) in task with Id.9 w - á á - 1)
NoT-FktCredit 220 Insufficient units on the target system w - - - - -
w
á
-
Default setting
possible
not possible
1)
Adjustable in the DDS under ”Project” + ”Exception handling”
Show/Hide Bookmarks