Lenze 9300 Servo PLC - 2.2.2 Outputs_AIF1 (AIF1_OUT)

9300 Servo PLC
System blocks
2.2 Automation interface (AIF1_IO_AutomationInterface)
2-7

9300ServoPLC EN 1.4
2.2.2 Outputs_AIF1 (AIF1_OUT)
Automation interface (module number 41)
This SB is used as an interface for output signals from plugged-in fieldbus modules (e.g. INTERBUS,
PROFIBUS-DP) for setpoint/actual values as binary, analog or phase-angle information.
• Theprocessimageis
– created in a cyclic task in a fixed time period of 10 ms
– created in an interval task within the time set for this task.
When the task is started, the process image is read and when the task is completed, the
task is written.
Tip!
Pleaseobserve thecorresponding OperatingInstructions for thefieldbusmodulethat is plugged in.
AIF1_OUT
Byte 1,2
Bit 15
B y te 7 ,8
B y te 5 ,6
Autom ation
In te rfa c e
B y te 3 ,4
AIF1_dnO utD 1_p
16 Bit
Low W ord
16 Bit
H ighW ord
16 Bit
Low W ord
16 Bit
H ighW ord
C 0859
AIF1_bFD O 0_b
AIF1_nO utW 1_a
C 0858/1
AIF1_bFD O 15_b
...
AIF1_nO utW 2_a
AIF1_nO utW 3_a
C 0858/2
C 0858/3
AIF1_bFD O 16_b
AIF1_bFD O 31_b
...
Bit 0
C 0151/4
A IF 1 _ w D c trlS ta t
16 Bit
Abb. 2-5 Outputs_AIF1 (AIF1_OUT)
Show/Hide Bookmarks