• If a call is received during a manual contact list transfer (OPP), the call will be
received on the cellular phone itself. Calls cannot be made from the onboard
device during manual transfer.
• If the cellular phone supports neither automatic contact list transfer (PBAP) nor
manual contact list transfer (OPP), contact data cannot be transferred using Blue-
tooth
®
. Note that the contact data can be transferred using a USB flash drive.
• If the engine switch <power switch> is turned off during contact list transfer, the
transfer will be canceled. In this case, start the engine <hybrid system> and carry out
transfer operations again.
● In the following cases, the contact data being transferred is not saved. (Some of the
transferred data is not saved either.)
•
When automatic transfer (PBAP) ends in the middle due to the memory capacity of
the multimedia system.
•
When automatic transfer (PBAP) is interrupted for some reason.
● The multimedia system’s contact data cannot be transferred to the cellular phone.
●
During contact data transfer, the Bluetooth
®
audio connection may be disconnected.
It will be reconnected once transfer is complete. (Reconnection may not be possible
for some models)
● When transferring, make sure the multimedia system has been started.
● The automatic contact data transfer (PBAP) function enables the transfer of contacts,
favorites, and history to the multimedia system. Some cellular phone models do not
allow favorites to be transferred.
● If [Sync contacts] is on, cellular phone favorites will be automatically transferred to the
multimedia system.
● Depending on the model, it may be necessary to perform operations on the cellular
phone when transferring contact data with automatic contact data transfer (PBAP).
● If you want to transfer contacts by automatic transfer (PBAP), you need to enable the
contact sharing setting on your cellular phone.
● If automatic contact data transfer (PBAP) does not start, it may start when all other
functions have completed.
● To display contact images, set [Display contact images] to on in the Bluetooth
®
settings. To transfer the contact image data, [Sync contacts] and [Display contact
images] must be set to on in the Bluetooth
®
settings.
Related Links
Bluetooth
®
specifications and compatible profiles(P. 111)
Setting Bluetooth
®
devices(P. 103)
6-7. Editing contact data
246
To Next Page
Loading...
