LOYTEC L-DALI - Page 353

To Next Page

To Previous Page

L-DALI User Manual 353 LOYTEC

Version 5.2 LOYTEC electronics GmbH

 Helvar Digidim 311/312/313/314/317

 OSRAM DALI Professional Sensorcoupler series

 OSRAM DALI HIGHBAY Adapter

 OSRAM LS/PD LI

 Philips OccuSwitch DALI LRM2090/20 and LRM2090/30 (occupancy only, see

Section 8.4.4.4)

 ThebenHTS PlanoSpot 360 DALI (see Section 8.4.4.6).

Typically these devices offer occupancy and light level sensor functionality. In addition

they usually also offer occupancy and constant light controller functionality. The L-DALI

allows utilizing the sensor functionality. If it is intended to also use the controller

functionality the installation software of the devices vendor must be used to install and

parameterize the device as this is not supported by the L-DALI.

In addition the following special sensor is supported:

 Lunatone DALI Temp-Sensor (see Section 8.4.4.7).

If you need support for a DALI sensor not listed above please contact LOYTEC.

DALI Buttons

As for sensors the “DALI switches”, “DALI buttons”, “DALI touch panels”, or remote

controls connected to DALI sensors use proprietary extensions of the DALI protocol.

DALI buttons can be used together with the L-DALI in two different way:

 Manual control of DALI groups (dimming lights, scene recall). See Section 5.3.4.7

and 7.6 on how to configure which button input performs witch function.

 Mapping DALI button inputs to network variables on the LONMARK interface of

the L-DALI (LDALI-10x only, see Section 8.2.11).

As of now the L-DALI supports the following DALI buttons

 LOYTEC LDALI-BM1 (see Section 8.4.4.2).

 LOYTEC LDALI-MS1 IRT (infrared receiver, see Section 8.4.4.1)

 Philips IRT 8080 IR-remote control with Philips OccuSwitch DALI LRM2090

(mapping to LONMARK interface only).

Other DALI devices

Different other proprietary DALI devices are currently not supported by the L-DALI. That

is, they cannot be commissioned or parameterized using the L-DALI and they are not

mapped to LONMARK or BACnet objects like DALI ballasts or supported DALI sensors and

DALI buttons.

However, such devices may be operated in a network controlled by the L-DALI. In this case

they must be commissioned and parameterized using the installation software of the

device’s vendor.