9HUVD3XOVHPowerSuite6HULHV6HUYLFH0DQXDO 7528%/(6+227,1*
5(9%
LED2 LAMP2 GRN When the system is driving lamp #2 fiber optic
cable to the HVPS. The LED blinks whenever
the laser fires and during power self-test of the
HVPS.
LED3 LAMP3 GRN When the system is driving lamp #3 fiber optic
cable to the HVPS. The LED blinks on whenever
the laser fires and during power on self-test of
the HVPS.
LED4 LAMP4 GRN When the system is driving lamp #4 fiber optic
cable to the HVPS. The LED blinks on whenever
the laser fires and during power on self test of
the HVPS.
LED5 LMOD GRN Indicates when the system is driving the lamp
modulation fiber optic cable to the HVPS. The
LED is being frequency modulated and will
appear as a variable intensity.
LED6 LVOLT GRN Indicates when the system is driving the lamp
voltage control fiber optic cable to the HVPS.
The LED is being frequency modulated and will
appear as a continuous intensity.
LED7 CROWB RED Indicates when the system is sending a crowbar
drive signal to the HVPS. The LED will blink
during power on self test of the HVPS.
LED8 CBOK GRN Indicates when the HVPS is sending a crowbar
OK return signal. The LED will blink for .5 sec.
everytime the crowbar is fired. The LED will
also blink during power on selftest of the HVPS.
LED9 VFFB GRN Indicates when the HVPS is sending a V-to-F
feedback return signal. The LED will blink every
time the crowbar is fired. The LED will also
blink during power on self test of the HVPS.
LED10 REM5V GRN Indicates when the remote control +5V supply is
on. The LED is lit when J16-8 is pulled low by
way of a jumper connection to J16-7 in the
remote control LEMO connector.
To Next Page
Loading...
