9HUVD3XOVHPowerSuite6HULHV6HUYLFH0DQXDO 7528%/(6+227,1*
5(9%
LED23 INAD RED Indicates that the inadvertent exposure monitor
was tripped. This situation occurs when neither
footswitch is depressed, the safety shutter was
fully open and the minimum light energy
detector was active.
LED24 ATNIN GRN Indicates that the main 40% attenuator is in
place.
LED25 REMTX/REMRX GRN/RED If the LED is green, this indicates that there is
communication on the remote control transmit
line. If the LED is red, then there is
communication on the remote control receive
line.
LED26 SATNIN GRN Indicates that the service attenuator is in place.
LED27 MTX/MRX GRN/RED If the LED is green, this indicates communication
on the DEECNO transmit line. If the LED is red,
this indicates that there is communication on the
DEECNO receive line.
LED28 CH_A/CH_B RED/GRN (RED) Indicator of the Channel A servo motor
encoder bit from the laser servo motor.
(GREEN)
Indicator of the Channel B servo motor encoder
bit from the laser servo motor.
LED29 PULSE/SIGN GRN/RED (GREEN) It is an indicator of the PWM output of
the HCTL110 servo motor controller. This is the
pulse width modulate control bit from the servo
controller. (RED) It is the indicator of the sign
output of the HCTL110 servo motor controller.
This is the direction control bit from the servo
controller.
LED30 INDEX GRN It is an indicator of the index or home position
from the servo motor encoder.
LED31 AS/ /AS/ GRN/RED (GREEN) This indicates when the address strobe
from the microprocessor is high. Both LEDs
must be flashing without being illuminated
continuously. (RED) Indicates when the address
strobe from the microprocessor is low. Both
LEDs must be flashing without being
illuminated continuously.
To Next Page
Loading...
