\\Table of contents
LTO
INSTALLATION
Unpacking the machine 1.8
Warning
Procedure
Removing the shipping rails 1.10
Conditions
Procedure
Preparing the bench 1.11
Machine dimensions
Space and drilling required
Water connections 1.12
Specifications
General
Filtration tank with pump
Pump
Pipe connections
Locate the connecting points
Procedure
Shipping safeties 1.15
Remove the shipping safeties
Procedure
Electrical connections 1.16
Specifications
Edger wiring
Procedure
Starting the edger 1.17
Procedure
Switching the machine ON/OFF
PRECAUTIONS FOR USE
Safety 2.19
Operator
Machine
Recommendations 2.20
USING YOUR EDGER
Presentation 3.23
Presentation of the machine
Description of the stations
Touch screen
Blocking / centering system
Scanform (emotion2 only)
Shape creator function
Digiform
Drilling
Edger
GRAVITECH™
Presentation of the application screen
Work interface
Visual references
Usual procedure 3.27
Job creation/selection
Calling up a job
Calling up a job saved in the memory
Saving a job/shape in the shape base
Scanform
Gravitech™ optical plotter
Lens tracing
Positioning / Start of capturing
Entering the bridge value
Choosing the frame
Mirror function
Digiform
Presentation
Deforming the shape of a job
Pivoting the shape of a job
Drilling
Positioning of drilling holes
Limits of hole positioning
Limits related to the thickness of the lens
Shape creator function
Presentation
Procedure
Blocking / centering system
Main blocking screen
Marking type for Live blocking
Lens characteristics
Edging
Presentation
Lens materials
Types of lenses
Finishing
Sub-finishing and associated parameters
Safety bevels
Polishing
Special case 3.67
Applying an oversize
Why?
How?
Hints
Important notes
Limits
Edging the left lens with different parameters from
those of the right lens
Principle
Procedure
Checking a finishing before the lens is edged
Principle
Presentation
Visualise a finishing
Place a finishin
g manually
Produce a manual bevel
Produce a manual groove
Feel the lens again
Points to remember 3.78
CONFIGURATION
Presentation of configuration menus 4.81
Presentation of the configuration menu access screen
Screen description
Access / Exit
Presentation of the personalisation menu access
screen
Screen description
Access / Exit
Adjustment of setting values 4.83
Preliminary remarks
Procedure
Saving the new configuration
Limits
Correction of frame and lens values 4.85
Preliminary remarks
Procedure
Configuration of general operating
parameters 4.87
Presentation
Principle
Screen description
Access / Exit
Configuration of the functions
Selecting the dialog language
Enabling size compensation according
to temperature
Enabling size compensation according to wheel condition
To Next Page
Loading...
