Configuration...Configuration of general operating parameters
4-88
LTO
4.4.2 CONFIGURATION OF THE FUNCTIONS
4.4.2.1 SELECTING THE DIALOG LANGUAGE
To select the dialog language, press this button until the desired language is displayed.
4.4.2.2 ENABLING SIZE COMPENSATION ACCORDING TO TEMPERATURE
4.4.2.2.1 PRINCIPLE
The water temperature affects the degree of expansion of the wheels.
Activating the temperature compensation automatically corrects for the expansion of the edging wheels and
the lens due to water temperature variations.
Enabling the temperature compensation is strongly recommended if you work in closed circuit mode.
4.4.2.2.2 PROCEDURE
To enable the temperature compensation:
4.4.2.3 ENABLING SIZE COMPENSATION ACCORDING TO WHEEL CONDITION
4.4.2.3.1 PRINCIPLE
A wheel becomes very abrasive after dressing. This can lead to some instability in the dimensions of edged
lenses following wheel dressing.
The wheel condition compensation function takes this effect into account and allows for compensation of the
lens size after the wheel has been dressed.
4.4.2.3.2 PROCEDURE
To enable wheel condition compensation:
4.4.2.4 ENABLING SIZE COMPENSATION ACCORDING TO THE BOWING/FLATTENING OF THE
FRAME
4.4.2.4.1 PROCEDURE
To enable the frame bowing/flattening compensation:
4.4.2.5 ACTIVATING THE DUAL JOB FUNCTION
4.4.2.5.1 PROCEDURE
To activate the dual JOB function:
4.4.2.6 CONFIGURING THE OMA
4.4.2.6.1 PRINCIPLE
The OMA 3.07 configuration is used to receive and drill rectangular holes sent via an OMA server also
operating in the OMA 3.07 configuration
4.4.2.6.2 PROCEDURE
To select the OMA version
To Next Page
Loading...
