Using your Edger...Special case
3-77
LTO
3.3.3.7 FEEL THE LENS AGAIN
If the diameter of the lens being felt is too small, the warning message "Lens too small" is displayed and you
transfer to the manual finishing screen.
You may then feel the lens three times successively. The lens is felt 0.5 mm closer to the interior
each time.
If the three successive feeling operations are not enough, the lens is too small and cannot be edged.
Confirm the message.
Complete the cycle and retrieve the lens.
If irregular points have been detected during the first phase of the cycle, the message "Irregular points" is
displayed and you transfer to the manual finishing screen. We advise you to repeat the lens feeling cycle.
To Next Page
