Using your Edger...Special case
[If desired]
Restart of feeling,
if necessary
The manual finishing screen is displayed.
By default, the middle of the groove is positioned
at 1/3 of the lens thichness from the front face.
Move the finishing and position it as you wish.
[To the rear]
[to the front]
=>Scan the lens profile, as you wish.
[To the front]
[To the rear]
Check that finishing = -
Position
the middle of the groove
at another point?
Yes
No
Modify the groove parameters, if desired.
[Depth]
[Width]
Check the position of the groove with reference to the lens profile:
Zone : Press the angular position index.
B
Starting the finishing cycle
once the position has been defined
To Next Page
Loading...
