5-2
Application Manual CDA3000
5 Software functions
5.5 Open-loop and closed-loop control .....................5-96
5.5.1 _31 MB-Motor holding brake ............................. 5-96
5.5.2 _32 MP-MOP function ....................................... 5-99
5.5.3 _59 DP-Driving profile generator .....................5-102
5.5.4 _27 FF-Fixed frequencies ................................ 5-107
5.5.5 _60 TB-Driving sets ......................................... 5-109
5.5.6 _65 CS-Characteristic data switchover (CDS) ..5-112
5.5.7 _66 MS-Master/-Slave operation ..................... 5-114
5.5.8 _67 BR-DC braking ......................................... 5-117
5.5.9 _68 HO-DC holding ......................................... 5-120
5.5.10 _80 CC-Current controller ................................ 5-122
5.5.11 _64CA-Current-controlled startup .................... 5-124
5.5.12 _69 PM-Modulation ......................................... 5-129
5.5.13 _84 MD-Motor data ......................................... 5-132
5.5.14 _77 MP-Remagnetization ................................ 5-134
5.5.15 _86SY-System ................................................ 5-136
Control method parameters:
6 “Control modes”.
Overview of all parameters:
Appendix A “Overview of parameters”.
Explanatory notes on the following tables
“Online” column
Many parameters can be altered online that is to say the changed value
takes effect immediately. This means a change in parameter value need
only be confirmed by pressing the Enter key.
Therefore these parameters do not require controller initialization by
briefly removing the enable signal ENPO or the start signal.
“Factory setting” column (“FS”)
The factory settings are identified by the abbreviation FS. The following
lists and tables contain all parameters up to user level 01-MODE = 4 in
their factory setting (152-ASTER = DRV_1).
To Next Page
Loading...
