5-14
Application Manual CDA3000
5 Software functions
Settings with 166-UDSSL for switchover of the active user data
set
User data sets cannot be switched “online”. The hardware enable via the
“ENPO” signal may still be applied, but the inverter module power stage
must be inactive. This means no start signal must be present in the
switchover phase.
BUS KP/DM Function
0 PARAM Switchover by direct editing of the parameter
1 TERM
Switchover by input with function selector setting UM0 (significance 2
0
)
or UM1 (significance 2
1
)
2 SIO Switchover by SIO control word (RS 232 port)
3 OPTN1 Switchover by control word of option module to slot 1
4 OPTN2 Switchover by control word of option module to slot 2
Table5.7 Settingsforswitchoveroftheactiveuserdatasetwith166-
UDSSL
To Next Page
