262335 33 Revision A
Figure 3.43: Forming Shield Attached to the
Windrower Frame
5. Lift the aft end of the forming shield and attach straps (B)
to pins (A) on the windrower frame. Install the washer and
the hairpin to secure the strap. Use the middle hole and
adjust the height to suit the crop.
Figure 3.44: Side Deflectors and Fluffer Shield
6. Set the forming shield side deflectors to the desired width
by positioning adjuster bars (A). Use the same hole location
on both sides.
• Position the deflectors at the narrowest setting for a
narrow windrow (silage for example).
• Position the deflectors at the widest setting for a wide
windrow.
7. Adjust fluffer shield (C) to the middle position. Loosen
handles (B) if required.
ASSEMBLING THE MACHINE
To Next Page
Loading...
