Section
Summary of Change
Internal Use
Only
Removing Steel Tines, page 208
Replaced the following DANGER with the following DANGER:
• Old DANGER: To prevent bodily injury or death from the
unexpected start-up or fall of a raised machine, always stop the
engine, remove the key, and engage the safety props before
going under the header for any reason.
• New DANGER: To prevent bodily injury or death from the
unexpected start-up of the machine, always stop the engine
and remove the key from the ignition before making
adjustments to the machine.
Moved Step 4, page 208 to after the engine is shut off.
Technical
Publications
Removing Bushings from Five-,
Six-, or Nine-Bat Reels, page 211
Replaced the following DANGER with the following DANGER:
• Old DANGER: To prevent bodily injury or death from the
unexpected start-up or fall of a raised machine, always stop the
engine, remove the key, and engage the safety props before
going under the header for any reason.
• New DANGER: To prevent bodily injury or death from the
unexpected start-up of the machine, always stop the engine
and remove the key from the ignition before making
adjustments to the machine.
Moved Step 4, page 211 to after the engine is shut off.
Technical
Publications
7.4 Header and Drapers, page
263
Added NOTE to troubleshooting information for upper cross auger
beater bars because the new UCA kits do not have beater bars
• Some newer upper cross augers do not have beater bars.
ECN 61273
—
Removed “Vertical Knife Mounts ” topic because the vertical knife is
not recommended for use with windrowers.
Product
Support
6.4.3 Draper Clips, page 251 Added topic.
ECN 54224
ECN 58960
8.3 Unloading and Assembly,
page 280
Corrected part numbers of the unloading and assembly manuals.
Technical
Publications
214327 vi Revision B
To Next Page
Loading...
