REPAIR INSTRUCTIONS, PART 1
Page 111
General Instructions
[210 EN]
This section includes step-by-step procedures for
disassembly of the engine. After cleaning
components, store them where they will remain
clean until needed for reassembly.
Failure to follow the sequence of operations may
result in damage to components or personal
injury.
Mounting the Engine on a Repair
Stand
[200 EB]
If the engine is to be mounted on a repair stand
by means of a mounting plate attached to its left
side, the mounting surfaces must be clear of
obstruction.
107
Figure 107 — Components to be Removed Before Mounting on a Repair Stand — LCF Chassis
1. Venturi Housing
2. EGR Mixer Inlet Tubing
3. EECU Cooling Plate
4. EECU
5. Fuel Filters
6. CCV Separator Tubing
7. CCV Separator
To Next Page
Loading...
