Mack MP7 - Oil Filter Housing Removal

REPAIR INSTRUCTIONS, PART 1
Page 127
Oil Filter Housing Removal
[219 EP]
Use suitable rags and containers for collecting oil
drainage.
1. Remove the clamp screw and banjo fitting
screw, and remove the oil cooler coolant
drain tube.
2. Mark the orientation of the oil filter
housing-to-oil cooler inlet and outlet tubes
for assembly.
143
Figure 143 — Oil Filter Housing-to-Oil Cooler Inlet and
Outlet Tube Orientation
3. Remove two mounting screws from the oil
filter housing and replace them with short
alignment pins. Remove the remaining oil
filter housing mounting screws.
4. Pull the oil filter housing off the alignment
pins and remove from the engine. Remove
the filter housing gasket and discard.
144
Figure 144 — Removing Oil Filter Housing
5. Remove the inlet and outlet tubes from the
oil cooling duct cover. Remove and discard
the tube seal rings.