Page 232
REPAIR INSTRUCTIONS, PART 1
Coolant Pump Installation
[ 215 SW, SG, SR]
328
Figure 328 — Coolant Pump Housing
1. Assemble the angle bracket on the cylinder
block.
2. Install the seal on the back of the coolant
pump housing.
3. Install the coolant pump housing on the
angle bracket and the cylinder block.
4. Using a torque wrench, tighten the angle
bracket screws according to specification.
5. Using a torque wrench, tighten the coolant
pump housing screws in a cross pattern
according to specification.
6. Install a new seal on the back of the coolant
pump.
329
Figure 329 — Installing Coolant Pump Seal
7. Assemble the coolant pump on the coolant
pump housing.
Be sure the seal is properly assembled before
tightening the screws.
330
Figure 330 — Coolant Pump and Housing
8. Using a torque wrench, tighten the screws
according to specification.
9. Install the 10-rib idler bracket on the cylinder
block and front engine support.
10. Install the belt tension idler bracket on the
cylinder block and front engine support.
11. Assemble the idler bracket on the coolant
pump housing.
1. Coolant Pump Housing 2. Angle Bracket
1. Coolant Pump Housing 2. Coolant Pump
To Next Page
Loading...
