Page 284
REPAIR INSTRUCTIONS, PART 2
4. Using the valve spring compressor,
9990210, install the valve spring and valve
retainers. Carefully tap on the valve stem
with a plastic or rubber hammer to ensure
that the valve keepers are positioned
correctly.
Use protective goggles or eye injury could
occur.
5. Move the valve spring compressor to the
next cylinder of the cylinder pair and repeat
the procedure. Rotate the crankshaft so that
the pistons are at TDC for the next cylinder
pair and repeat the procedure. Continue on
and repeat the procedure for the final
cylinder pair.
Final Steps
Install the following components that were
removed for access to the valve stem seals
(see ENGINE REASSEMBLY for procedures):
앫 Unit Injectors
앫 Rocker Arm Shaft Assembly
앫 Cylinder Head Cover
To Next Page
Loading...
