REPAIR INSTRUCTIONS, PART 1
Page 131
Fan Drive, Idler and Fan Bracket
Removal
[232 HB]
1. If not already done, remove and set aside
the drive belts.
2. If not already done, disconnect the fan pigtail
from the wiring harness.
3. Remove the fan drive with fan from the fan
hub.
151
Figure 151 — Idler with Idler Bracket
4. Remove the idler with idler bracket from the
coolant pump housing.
Fluid will leak from the fan drive if it is placed with
the mounting hub down. Ensure that the fan drive
is stored as illustrated in the following figure.
152
Figure 152 — Viscous Fan Drive Assembly Storage
5. Remove the fan hub from the fan hub
bracket.
6. Remove the fan hub bracket from the lifting
eye bracket.
1. Idler 2. Coolant Pump Base
Plate
1. OK to Store with Fan
Blade in Vertical
Position.
2. OK to Store with Fan
Blade in Horizontal
Position and Mounting
Flange Up. Do Not
Store
with Mounting Flange
Down.
To Next Page
Loading...
