Page 146
REPAIR INSTRUCTIONS, PART 1
Crankshaft Vibration Damper and
Fan Pulley Removal
[212 RB, 216 1A]
When handling a vibration damper, be careful not
to damage the housing. Dents in the outer
housing may render the damper ineffective. The
vibration damper cannot be repaired. Failure to
heed this caution may result in severe engine
damage.
The fan pulley nests within the damper using the
same attaching screws.
186
Figure 186 — Vibration Damper and Fan Pulley
1. If not already done, release the tensioners
and remove the drive belts.
2. Remove the front engine power take-off
(FEPTO) unit if so equipped.
3. Remove the fasteners and crankshaft
vibration damper and fan pulley.
Crankshaft Front Cover Removal
[211 JB]
187
Figure 187 — Crankshaft Front Cover
1. While supporting the front cover, remove the
eight fasteners attaching the cover to the
cylinder block.
2. Remove the crankshaft front cover from the
engine by sliding it off the crankshaft flange.
1. Pulley, Fan Drive and
Coolant Pump
2. Vibration Damper/Pulley
3. Crankshaft Hub
1. Front Cover 2. Crankshaft Hub
To Next Page
Loading...
