REPAIR INSTRUCTIONS, PART 1
Page 145
REMOVING THE CYLINDER HEAD
With the timing gear plate-to-cylinder head
screws removed (A, B and C in Figure 180),
proceed as follows to remove the cylinder head.
184
Figure 184 — Cylinder Head Removal
1. Remove the cylinder head screws.
2. Using the cylinder head lifting tool,
85109049, carefully remove and set aside
the cylinder head.
3. Remove and discard the cylinder head
gasket.
185
Figure 185 — Cylinder Liner Retainer
4. Attach cylinder liner hold-down tools,
9996966, to the cylinder block to keep the
liners in place temporarily.
1. Cylinder Head
2. Lifting Tool, 85109049
3. Alignment Pins
4. Cylinder Block
To Next Page
Loading...
