Page 250
REPAIR INSTRUCTIONS, PART 1
Alternator and Refrigerant Compressor Installation
[271 CB, 264 DP]
365
Figure 365 — Alternator and Refrigerant Compressor Mounting
1. Assemble the alternator and refrigerant
compressor mounting bracket on the
cylinder block.
2. Using a torque wrench, tighten the screws
according to specification.
3. If removed, assemble the belt tension idler
on the bracket.
4. Using a torque wrench, tighten the screws
according to specification.
5. Install the alternator on the mounting pads.
6. Using a torque wrench, tighten the screws
according to specification.
7. Install the refrigerant compressor on the
mounting pads.
8. Using a torque wrench, tighten the screws
according to specification.
9. Securely connect the electrical wiring as
tagged during disassembly.
10. Assemble the refrigerant lines on the
compressor.
11. Assemble the belt pulleys on the alternator
and compressor hubs.
1. Mounting Bracket
2. Alternator Mounting Pads
3. Refrigerant Compressor Mounting Pads
To Next Page
Loading...
