REPAIR INSTRUCTIONS, PART 1
Page 249
5. Attach the line to the cylinder block with a
strap clamp.
6. Attach the two pipes between the top of the
cylinder head at the front and the fuel filter
housing.
7. Attach the two lines to the cylinder block with
three strap clamps.
8. Attach the pipe connecting the fuel filter
housing to the EECU cooler.
9. Using a torque wrench, tighten the banjo
fittings according to specification.
Crankcase Ventilation Separator
364
Figure 364 — Crankcase Ventilation System Separator
1. Install the crankcase ventilation separator on
the cylinder block.
2. Using a torque wrench, tighten the screws
according to specification.
3. Assemble the outlet hose on the ventilation
separator outlet connector.
4. Using a torque wrench, tighten the screws
according to specification.
5. If turbocharger connection is required,
assemble the outlet hose on the
turbocharger connector.
6. Using a torque wrench, tighten the screws
according to specification.
7. Assemble the inlet hose on the ventilation
separator inlet and valve cover outlet
connectors.
8. Using a torque wrench, tighten the screws
according to specification.
1. Separator Inlet Hose and Connector
2. Separator Outlet Hose Connector
3. Turbine
4. Drive Shaft
5. Separator Discs
6. Pressure Regulator
7. Pressure Regulator Diaphragm
To Next Page
Loading...
