Page 196
REPAIR INSTRUCTIONS, PART 1
Crankshaft Installation
[212 HP]
The crankshaft is heavy. Do NOT attempt to
install the crankshaft without the help of an
assistant or the use of a suitable lifting
device. Failure to heed this warning may
result in severe personal injury and
component damage.
251
Figure 251 — Crankshaft and Main Bearing Caps
1. Be sure that the crankshaft and the
crankcase area of the cylinder block are
clean.
2. Thoroughly clean each main journal bore
and the back of each bearing before
installation. The bearings must be installed
dry.
1. Cylinder Block
2. Bearing Inserts, Upper
3. Crankshaft
4. Bearing Inserts, Lower
5. Main Bearing Caps
6. Thrust Washers
7. Bearing Cap Casting Nipple
8. Cylinder Block Casting Nipple
To Next Page
Loading...
