Page 242
REPAIR INSTRUCTIONS, PART 1
7. Connect the oil supply line to the bottom of
the turbocharger. With a new gasket, install
the turbocharger oil drain pipe, fasteners
and retaining clamp.
351
Figure 351 — Turbocharger Oil Supply and Drain
Connections
8. Tighten the oil drain pipe clamp screws
according to specification.
352
Figure 352 — Smart Remote Actuator (SRA) Coolant
Lines
9. Attach the coolant supply line to the SRA.
10. Attach the coolant return line to the SRA.
11. Using a torque wrench, tighten the fittings
according to specification.
Starter Installation
[272 DH]
The starter is held in place by nuts assembled
over studs inserted in the flywheel housing. If a
stud is missing, replace it.
353
Figure 353 — Starter Installation
1. Using a torque wrench, tighten replacement
studs according to specification.
2. Assemble the starter on the studs in the
flywheel housing.
3. Using a torque wrench, tighten the nuts
according to specification.
To Next Page
Loading...
