REPAIR INSTRUCTIONS, PART 1
Page 183
ROCKER ARM SHAFT BENCH
PROCEDURES
[213 LP]
Description
ROCKER ARM SHAFT
The MP7 rocker arm shaft is held in place by the
same screws that hold the inboard ends of the
camshaft bearing caps. A specific sequence for
tightening these screws is described in “MP7
ENGINE MECHANICAL SPECIFICATIONS” on
page 300.
240
Figure 240 — Rocker Arm Shaft
1. Rocker Shaft
2. Inlet Rocker Arm
3. Unit Injector Rocker Arm
4. Exhaust Rocker Arm
To Next Page
Loading...
