MAINTENANCE
Page 87
Oil and Filter Change Procedure
[219 EV]
79
Figure 79 — Oil Filters and Valve Housing
DISPOSABLE SPIN-ON OIL FILTER
REPLACEMENT
Change oil and replace oil filters using the
following procedure:
1. Run the engine until normal operating
temperature is reached. Then, shut off the
engine and drain the oil before the engine
cools.
2. Thoroughly clean the area around the filters
before removing.
3. Using filter wrench 9998487, remove both
spin-on filters and wipe the filter mounting
base clean.
4. Fill each filter with 1.9 liters (2 quarts) of the
specified engine oil. DO NOT allow any
contaminants to enter the filters while filling.
5. Apply a film of clean engine oil to the sealing
gasket on each new filter.
6. Install the filters and tighten 3/4 to 1 turn
after the gasket contacts the base.
7. Fill the crankcase with the recommended
engine oil. If the engine is equipped with a
REPTO unit, add one additional quart.
8. Start the engine and check for leaks. Run
the engine for approximately five minutes,
then shut it off and recheck the oil level. Add
oil if necessary.
1. EGR Valve
2. VGT
3. EGR Mixer
4. EGR Crossover Pipe
5. Coolant Conditioner
6. Full-Flow Oil Filters
7. By-Pass Oil Filter
8. EGR Cooler
9. Starter
To Next Page
Loading...
