REPAIR INSTRUCTIONS, PART 1
Page 135
1. Unlock and remove the end connectors
attached to the EECU. Remove the screws
from the harness retainer clamps. Push the
connector locks inward and rotate outward
to disconnect both wiring harnesses from
the EECU.
160
Figure 160 — EECU Harness Connectors
Use care to avoid damaging the terminal pins.
2. Position the harness connectors out of the
way.
Use suitable rags and containers for collecting
fuel drainage.
3. Remove the fuel lines from the cooling plate.
4. Remove the screws and the cooling plate
from the EECU.
161
Figure 161 — Cooling Plate Mounting Screws
5. Remove the screws and the EECU from the
engine.
162
Figure 162 — EECU Mounting Screws
Inlet Manifold Removal
1. Remove two of the top inlet manifold
mounting fasteners and install two alignment
pins to support the manifold during removal.
2. Remove the remaining inlet manifold
mounting fasteners. Using a plastic mallet,
carefully tap the manifold loose and remove
it from the cylinder head.
163
Figure 163 — Removing Inlet Manifold
3. Using a sharp pick, remove the rubber seal
(molded gasket) from the groove in the inlet
manifold. Discard the manifold seal.
To Next Page
Loading...
