REPAIR INSTRUCTIONS, PART 1
Page 253
Removing Engine from Engine
Stand
[200 EB]
The engine is extremely heavy. Make certain the
lifting device and hoist are of sufficient capacity to
bear the weight. It is necessary to have an
assistant help maneuver the engine during
removal and installation. Failure to heed this
caution may result in serious personal injury and
damage to the engine.
1. Attach a suitable lifting device to lifting points
on the engine.
2. Position and attach an engine hoist to the
lifting device. Operate the hoist to place
tension on the lifting device.
3. With the lifting device supporting the engine
weight, remove the mounting screws from
the engine stand.
4. Using the engine hoist, place the engine in a
suitable support rack or install the engine in
the vehicle (see Engine Installation in the
REPAIR INSTRUCTIONS, PART 1 section).
Filters and Miscellaneous
Components Installation
[219 EV, 215 LD]
This section covers installation of filters and other
components that might get in the way of other
assembly operations and to which nothing is
assembled.
1. If not already done, assemble the following
components on the engine using the
procedures covered earlier in this section:
앫 Venturi housing and mixer inlet tubing
앫 EECU and cooling plate
앫 Fuel filter housing and fuel lines
앫 Crankcase ventilation tubing
앫 Crankcase ventilation separator
To Next Page
Loading...
