Page 254
REPAIR INSTRUCTIONS, PART 1
371
Figure 371 — Components for Installation After Removal from Repair Stand
2. Pre-fill each new full-flow oil filter with 1.9L
(2 quarts) of the recommended engine oil.
Apply a thin film of clean engine oil to the
sealing gasket of the new filters. Install the
full-flow filters and tighten an additional 3/4
to 1 turn after the gasket contacts the base.
DO NOT allow any contaminants to enter the
filters while pre-filling.
The sequence in which the EGR venturi housing,
fuel filter housing, fuel lines and EECU are
assembled on the engine depends on the type of
engine stand used. For engine stands that use an
adapter plate attached to the left side of the
engine, these components cannot be installed
until after the engine has been removed from the
repair stand.
3. Pre-fill a new bypass oil filter with 1.9L
(2 quarts) of the recommended engine oil.
Apply a thin film of recommended engine oil
to the sealing gasket of the new filters. Install
the bypass filter and tighten an additional 3/4
to 1 turn after the gasket contacts the base.
DO NOT allow any contaminants to enter the
filters while pre-filling.
4. Apply a thin film of clean engine oil or
coolant to the sealing gasket of the new
coolant filter. Install the coolant filter and
tighten an additional 3/4 to 1 turn after the
gasket contacts the base.
1. Venturi Housing
2. EGR Mixer Inlet Tubing
3. EECU Cooler
4. EECU
5. Fuel Filters
6. Crankcase Ventilation Tubing
7. Crankcase Ventilation Separator
To Next Page
Loading...
