Page 248
REPAIR INSTRUCTIONS, PART 1
Fuel Lines and Fuel Filter Housing
Installation
362
Figure 362 — Fuel Filter and Filter Housing Assembly
1. Make sure that the pipe connected to the
fuel filter housing is securely fastened.
2. Assemble the fuel filter housing on the
cylinder block.
3. Using a torque wrench, tighten the screws
according to specification.
4. Attach the pipe between the side of the
cylinder head at the rear and the fuel filter
housing.
363
Figure 363 — Fuel Supply Pump, Fuel Filter Housing and Lines
1. Washers
2. Banjo Fitting
3. Banjo Screw
4. Power Steering Pump
5. Fuel Pump
6. Fuel Filter Housing
7. EECU Cooler
To Next Page
Loading...
