REPAIR INSTRUCTIONS, PART 1
Page 247
2. Using a torque wrench, tighten the screws
according to specification.
3. Assemble the cooler on the EECU. When
positioning the module, make sure that the
small ground strap at the upper right of the
unit is properly secured and pressed in
close.
4. Using a torque wrench, tighten the screws in
sequence according to specification.
5. Connect the fuel lines to the inlet and outlet
ports of the cooling plate.
361
Figure 361 — EECU and Cooling Plate
6. Connect the wire harness to the EECU.
Use care to ensure that the EECU terminal pins
are straight and undamaged.
1. EECU
2. EECU Attaching Screws
3. Cooler Attaching Screws
4. Cooler
5. Cylinder Block
6. Ground Strap
To Next Page
Loading...
