Page 128
REPAIR INSTRUCTIONS, PART 1
Coolant Pipe Removal
[215 SW]
Use suitable containers to collect coolant that
may escape during removal procedures.
1. Remove the screws and remove the upper
coolant pipe housing from the cylinder head.
Discard the flange seal ring.
145
Figure 145 — Upper Coolant Pipe (Bypass) Housing
2. Remove the screws and remove the pump
inlet pipe at the rear of the coolant pump
housing. Discard the flange seal ring.
146
Figure 146 — Removing Pump Inlet Pipe
To Next Page
Loading...
