REPAIR INSTRUCTIONS, PART 1
Page 243
Air Compressor Installation
[261 CK]
If the timing gears are in place, make sure the
gear teeth are properly meshed during assembly
of the air compressor.
354
Figure 354 — Installing Air Compressor Mounting Seal
1. Install a new seal in the air compressor
housing.
355
Figure 355 — Air Compressor Installation
2. Install the air compressor mounting flange
over the studs in the flywheel housing.
3. Using a torque wrench, tighten the attaching
nuts in two stages according to specification.
356
Figure 356 — Air Compressor Coolant and Lubrication Fittings
1. Lubrication Line
2. Banjo Fitting
3. Coolant Lines
4. Attaching Stud and Nut
5. Air Compressor
To Next Page
Loading...
