Page 132
REPAIR INSTRUCTIONS, PART 1
153
Figure 153 — Lifting Eye Bracket
7. Remove the lifting eye bracket from the
cylinder head and cylinder block.
EGR Crossover (Cooler Outlet) Pipe
Removal
[214 HN, HP, HR]
154
Figure 154 — EGR Crossover Pipe with Elastomer
Bushings
1. Loosen the clamps on each end of the
crossover pipe.
2. Using a pry bar, carefully pull the pipe away
from the cylinder block.
155
Figure 155 — Elastomer Bushing — Crossover Pipe
3. Remove and set aside the elastomer
bushings.
EGR Venturi Housing Removal
If not already removed, follow this procedure.
1. Loosen the connecting sleeve at the EGR
crossover pipe.
2. Remove the wiring at the sensor terminals.
3. Loosen the connecting sleeve at the EGR
mixer.
4. Detach the strap clamps holding the piping
to the cylinder block and brackets.
5. Detach the inlet piping from the venturi
housing.
6. Remove the inlet piping, venturi housing and
connector sleeves and set aside.
EGR Mixer Removal
[214 HL]
If not already removed, follow this procedure.
1. Remove the EGR mixer, air heater and
gasket from the inlet manifold.
2. Discard the gasket.
3. Set the mixer and air heater aside.
1. Hex-Head Screws
2. Socket-Head Screws
3. Crossover Pipe
4. Lifting Eye Bracket
1. Crossover Pipe 2. Elastomer Bushings
To Next Page
Loading...
