REPAIR INSTRUCTIONS, PART 1
Page 165
3. Using clean engine oil, press the wrist pin
into the bore.
4. Insert a snap ring in the other wrist pin
groove of the piston.
5. Set the assembled piston aside in a clean
location until it is needed.
6. Repeat steps 1 through 5 for each piston.
Connecting rod capscrews can only be re-used
four times. Screw heads must be punched at
each overhaul to indicate the number of times
used. Failure to heed this caution may result in
severe component damage.
A screw with four punch marks (A) must be
replaced with a new screw.
214
Figure 214 — Connecting Rod Screw with Maximum
Punch Marks (Replace)
Used connecting rod screws must be lightly oiled
on the threads and under the head. New screws
are coated with phosphate and oil and must be
assembled dry.
If the screws are incorrectly assembled or
tightened to an incorrect torque, the assembly
must be discarded. Failure to heed this caution
may result in severe component damage.
To Next Page
Loading...
