Page 230
REPAIR INSTRUCTIONS, PART 1
322
Figure 322 — Flywheel Installation
2. Install the flywheel mounting screws in the
exposed mounting holes. At this time,
tighten the screws finger-tight only.
3. Remove the two alignment studs and insert
the remaining mounting screws.
4. Using a torque wrench, tighten the screws in
sequence according to specification.
323
Figure 323 — Flywheel Installation Torque Sequence
For this engine, NO snap ring is required on the
pilot bearing. Do NOT substitute pilot bearings
that do not bear the correct part number for this
application. Failure to heed this caution may
result in severe engine damage.
5. Using tool assembly, 9991801 and 9992564,
install a new pilot bearing in the flywheel
bore.
6. Carefully install the flywheel position sensor.
Install the retaining screw and tighten
according to specification.
324
Figure 324 — Flywheel Position Sensor
To Next Page
Loading...
